Rendering

Render that lasts is render that's bonded.

Most render on Sydney buildings doesn't fail because of the mix. It fails because it was applied over a surface that couldn't hold it, or because water found a way in behind it and pushed it off. Tap a wall and you'll hear it — the hollow sound is render that's already let go, waiting for a wet week to come down.

We re-render façades from rope, which means the whole elevation gets treated as one surface instead of being patched a storey at a time as each section fails.

Drummy, cracked, or coming off

Three different problems, three different fixes, and the wrong one wastes your money.

Drummy render has debonded from the substrate. It looks fine from the ground and sounds hollow under a tap test. Patching over it does nothing — it has to come off back to solid material.

Cracked render is either movement or shrinkage. Movement cracks reopen if you just fill them, so they get routed and treated as a joint. Shrinkage cracking is cosmetic and coats over.

Blown or spalled render usually means water or corroding steel behind the wall. That's a remedial fix first — re-rendering over an active cause just buys you eighteen months.

We tap-test the elevation before quoting so you're paying to re-render what actually needs it, not the whole building by default.

What we do

Full elevation re-render — existing render removed, substrate prepared, new render applied and finished to match

Cut-out and patch repairs — isolated drummy or damaged areas made good and blended into the surrounding texture

Crack routing and repair — movement cracks opened, treated and sealed rather than skimmed over

Texture matching — sand, sponge, trowel and roll-on finishes matched to the existing façade